Start a compressor by checking the oil, power, drains, and guards first. Then start it with the outlet closed or nothing connected, watch and listen as it builds pressure, and shut it down cleanly. Your compressor’s manual has the exact steps for your model, and where it differs from this guide, the manual governs. Gas-engine and engine-driven units have their own steps.
A note on “starting air”
In diesel and power-plant settings, “starting air” means high-pressure air used to start an engine. This article is about starting a shop or home air compressor, not that.
Before you start
Check the oil
Oil-lubricated pumps need oil at the level marked on the sight glass or dipstick. Check it before every start, use the type the manual specifies, and change it on schedule. Some oil-free designs have no pump oil to check, so follow the maker’s instructions for your model.
Check power
Confirm the voltage matches the nameplate (see 120V vs 240V air compressors). Make sure the outlet or circuit is in good condition and the cord is undamaged. Don’t run the compressor on a long, thin extension cord. For the circuit itself, see wiring a dedicated circuit for your air compressor.
Check drains and valves
Close the tank drain fully before starting. Set the outlet valve as the manual specifies. Make sure the safety relief valve is intact and not plugged.
Check belts, guards, and mounting
On belt-driven units, check belt tension and condition. Make sure guards are in place and that the unit sits stable on a firm, level surface.
Look for damage
Check hoses, fittings, and the tank for cracks, bulges, heavy rust, or leaks. Don’t run a compressor with a damaged tank.
Start the compressor
- Keep the outlet closed, or disconnect the tools, so the motor starts without a load. Many manuals recommend this.
- Stand clear of belts, pulleys, and moving parts. Know that some compressors start automatically when pressure drops.
- Start the unit with its switch.
- Watch the tank gauge as pressure rises. Listen for unusual noise.
- Let it run until it reaches its cut-out pressure and shuts off on its own.
Check that it’s working normally
- Pressure rises steadily, without long pauses.
- The motor and pump run smoothly, with no knocking, rattling, or squealing.
- There is no hissing at fittings or the tank.
- The unit doesn’t overheat or leak oil.
If any of these fails, stop the compressor and check the manual, or call a technician. For causes of low pressure, see why an air compressor won’t go over 40 psi.
Shut down
- Turn off the switch. Disconnect power if you won’t use the compressor again soon.
- Relieve the pressure as the manual describes, usually through the tank drain or a bleed valve.
- Keep the outlet closed.
After each use: drain the tank
Water collects in the tank as the air cools. Drain it after each use, or at least daily in humid conditions. Open the drain valve to release the water and pressure, and keep your face and body clear of the outlet. Keep it open until no more water comes out, then close it fully. Tank corrosion starts inside, so regular draining protects the tank and your tools. For other moisture controls, see compressed dry air.
Safety
- Disconnect power before service or belt work.
- Wear eye and hearing protection.
- Keep the relief valve intact. Don’t plug or change it.
- Keep cords and hoses away from hot areas of the unit.
Gas and engine-driven units
Gas or diesel-engine compressors have their own start-up steps for fuel, choke, and engine warm-up. Follow the engine and compressor manual for those steps. The checks above still apply: oil, drains, and the relief valve.
For the wider system, including the drains and shutoff valves that support daily use, see how to set up air compressor lines.