Shop Air Systems

Shutoff Valves and Drop Legs in Your Compressed Air Line

Where to put shutoff valves and drop legs in a compressed air line: at the tank, at each drop, and at the low end with a drain to keep water out of tools.

On this page
  1. Why shutoff valves matter
  2. Where to put a shutoff valve
  3. What a drop leg does
  4. How to build a drop
  5. Drain valves
  6. Order from the compressor
  7. Common mistakes
  8. Safety

Put a shutoff valve right after the tank outlet, a shutoff at each drop, and a drop leg with a drain at the bottom of each drop. Together these let you isolate sections for repair, collect water and debris before it reaches your tools, and drain the system safely.

Why shutoff valves matter

A shutoff valve lets you isolate part of the system. You can work on one drop without depressurizing the whole shop, find a leak by closing sections one at a time, or shut off a station you aren’t using. Without valves, every repair means shutting down the entire line.

Where to put a shutoff valve

  • At the compressor, right after the tank outlet, so you can isolate the piping from the tank.
  • At each drop, so you can isolate one work area.
  • At the feed to each tool station, if a station has several outlets.
  • Within easy reach. Put valves where you can operate them without a ladder or awkward reaching.

Ball valves are the usual choice for compressed air. They open fully with a quarter turn and seal well. Make sure the valve is rated for your system’s maximum pressure.

What a drop leg does

A drop leg is a short vertical section of pipe below the take-off from the main. Water and debris that travel along the line settle in the drop leg instead of flowing into the tool. The drain at the bottom of the drop lets you remove what collects. Make the drop long enough that water and debris collect below the take-off, not at the level of the outlet.

How to build a drop

  1. Take off the top of the main line.
  2. Run pipe down to the drop leg.
  3. Add a drain valve at the bottom of the drop leg.
  4. Add a shutoff valve so you can isolate the drop.
  5. Continue to the regulator, filter, and outlet, as the station requires.

Keep the drain reachable and the valve easy to operate. For the full layout, see how to set up air compressor lines.

Drain valves

Drain valves at the low points remove water. A manual drain works well if you check it regularly. Automatic drains remove water on a timer or with a float, but they need maintenance too. Choose one that’s easy to reach, and check it on your regular schedule.

Order from the compressor

A typical order from the tank is:

  1. Tank drain (close it after draining)
  2. Shutoff valve
  3. Leader hose
  4. Water separator or filter, with a drain
  5. Main line, sloped toward a drain

For moisture controls beyond drains, see compressed dry air. For what to check when a line that looks sound still leaks, see finding and fixing compressed air leaks.

Common mistakes

  • Taking the drop from the bottom of the main. Water flows along the bottom and goes straight into the tool.
  • Leaving out drains at low points. Water has nowhere to go.
  • Short drop legs. The drop leg has to be long enough to hold the water.
  • Valves in hard-to-reach spots. If you can’t reach a valve, you won’t use it.

Safety

  • Depressurize a section before you open a drain or work on a valve.
  • Direct drain discharge away from people and the work area.
  • Wear eye protection when you open drains, since water and debris can spray.

The complete guide to shop air systems

How to Set Up Air Compressor Lines in Your Shop
Read the guide

Keep exploring

Guides from other topics

All topics →