An FRL (filter-regulator-lubricator) unit combines three stages in one body. The filter removes water and particles, the regulator holds a steady outlet pressure, and the lubricator adds a fine oil mist for tools that need it. Most shops need the first two. Add the lubricator only for tools whose manuals call for inline oil, and skip it where oil would contaminate the work.
What each stage does
- Filter: Removes liquid water, rust, and particles. A bowl at the bottom collects what it removes, and the bowl needs draining.
- Regulator: Holds the outlet pressure steady, so the tool gets the pressure it is rated for, whatever the line pressure. See air compressor regulators.
- Lubricator: Adds a fine mist of oil to the air stream. Oil-lubricated tools rely on it for their internal parts. See how air tools work for what those parts do.
The correct order
Air flows through an FRL in one direction: filter first, then regulator, then lubricator. The arrow on the body shows the flow direction, and installing the stages backward defeats the purpose.
- The filter comes first, so water and particles don’t reach the regulator’s valve.
- The regulator comes next, so the outlet pressure is steady before the oil is added.
- The lubricator comes last, so the oil goes straight to the tool.
Do you need one?
- Filter: Useful for most shop use, especially if the line is damp or the compressor runs in a dusty area. If you also have a dryer, a coalescing filter ahead of it is the usual pick. See compressed dry air.
- Regulator: Useful when line pressure is higher than the tool needs, or when different tools at one drop need different pressures.
- Lubricator: Needed only when the tool’s manual calls for inline oil. Many pneumatic tools are designed to run with oil from a lubricator, and some are not.
Oil-lubricated and oil-free tools
Check each tool’s manual. Some tools need an inline lubricator to keep their internal parts working. Others are designed to run without one, and adding oil can cause problems. Oil mist can also contaminate paint and other finishes, so many people run spray equipment without an inline lubricator.
Sizing
Choose an FRL with a flow rating at least as high as your peak tool demand, and a port size that matches your piping. An undersized FRL restricts flow and drops pressure at the tool, just like an undersized hose. Port size tells you the fitting; the flow rating tells you whether the unit can keep up. For how to size a regulator, see air compressor regulators.
Setup tips
- Mount the unit upright, as the maker specifies, so the bowl and the lubricator work correctly.
- Follow the flow arrow.
- Set the regulator while air flows through a tool.
- Fill the lubricator with the oil type the maker specifies, and set the drip rate as the manual describes.
- Drain the filter bowl regularly.
Maintenance
- Drain the filter bowl daily, or as needed in humid conditions.
- Replace the filter element on the maker’s schedule.
- Refill the lubricator before it runs dry.
- Check the regulator for drift, and replace it if it won’t hold a setting.
Common mistakes
- Installing the stages out of order.
- Putting a lubricator on a line that feeds paint or finish work.
- Choosing an FRL that is too small for the tools.
- Forgetting to drain the filter bowl, so water carries over into the line.
For a full drop layout, see how to set up air compressor lines. For connections at the tool, see air coupler types.