Unplug the compressor first. Then open the drain valve at the bottom of the tank, let the air escape, and watch the tank gauge until it reads 0 PSI. Disconnect the hoses and tools. Only after the gauge reads zero should you work on fittings, valves, or the pump.
Before you start
- Unplug the compressor from the outlet. Do not rely on the switch alone.
- Wear eye protection. Air leaving a tank can carry rust, water, and oil.
- Keep your hands and face away from the drain valve and any fittings while the air escapes.
- Do not point the air at anyone. See what OSHA says about compressed air.
Drain the tank to zero
- Find the drain valve. It is usually a small valve or petcock at the lowest point of the tank, at the bottom.
- Open it slowly. Let the air and any water escape. Use a pan or a rag to catch the water.
- Watch the tank gauge. The reading should fall toward 0 PSI.
- Keep the valve open until the gauge reads 0 and the flow stops. A little water is normal. Close the valve once the gauge reads zero, unless you are storing the unit. For storage, check the manual before you leave it open. See how to winterize an air compressor for storage.
If there is no drain valve
Some tanks have no drain valve, or the valve is stuck. In that case, the tank’s safety valve can release the pressure. Pull the ring on the safety valve carefully, keep your face and hands clear, and let the air escape.
Do not remove or plug the safety valve. Do not try to force a stuck drain valve with pliers while the tank is still pressurized. If neither method releases the pressure, stop and get a qualified technician to help.
Release air from hoses and tools
Disconnect the hose from the compressor and from the tool. Pull the trigger on the blow gun or the tool to clear any pressure left in the hose. Point the hose end in a safe direction while you do this.
Release pressure in the pump head
Many piston compressors have an unloader valve that vents the pump head when the motor stops. That lets the motor restart without fighting the pressure. Some air venting from the unloader right after shutdown is normal.
Do not open the fittings on the pump head to relieve pressure. Let the unloader and the drain valve do the work. If the unloader does not vent, or it keeps hissing, see unloader valve symptoms.
If the gauge does not drop to zero
- Check the drain valve for debris or rust, and try again.
- Check whether the gauge is working. If you have a second gauge, compare the two readings.
- If the gauge still does not fall, stop. Do not open fittings, the pressure switch, or the tank while the gauge still shows pressure. Get help.
Why draining regularly matters
Water collects in the tank as the compressor works. Draining after each use removes that water and helps prevent rust inside the tank. The full routine is in the air compressor maintenance tips.