Most often, the outlet regulator is set near 40 psi, or the tank is leaking or venting. Check the tank gauge first. Then check the drains, leaks, the check valve, the pressure switch, and the pump, in that order. Most of these checks take a few minutes. Pump and safety-valve problems belong to a technician.
First check: which gauge shows 40 psi?
Compressors have two gauges. The tank gauge shows the pressure stored in the tank. The regulator’s outlet gauge shows the pressure sent to your tools. If the outlet regulator is set to 40 psi, the outlet will never read higher, even while the tank builds pressure normally.
To check, turn the outlet regulator up, or close the outlet entirely, and watch the tank gauge. If the tank climbs past 40 psi, the regulator was the limit. See how to adjust the pressure regulator.
Check for open drains
A drain valve left slightly open lets the tank bleed as fast as the pump fills it. Close the tank drain fully. Then check the drain valves on drops, separators, and filters. A drain that seeps can keep the tank from building pressure.
Look for leaks
Shut off the compressor, close the outlet, and watch the tank gauge. If the pressure drops quickly, something is leaking, either in the tank, its valves, or the lines. Brush soapy water on fittings and hose ends. Work through finding and fixing compressed air leaks.
Check the pressure switch
The pressure switch decides when the motor starts and stops. If its cut-out setting is low, the compressor stops at that pressure no matter what the pump can do. Read the switch’s settings on its cover or in the manual.
Adjusting the switch involves the motor’s electrical circuit. If you aren’t familiar with it, have a technician do it. A switch that stops at the same pressure no matter how you set it may be faulty. See replacing an air compressor pressure switch.
Check the check valve and unloader
The check valve sits between the pump and the tank, and it lets air flow in one direction only. If it leaks, air flows back toward the pump, and tank pressure falls quickly after shutdown.
Some pumps have an unloader valve that releases pressure from the pump head when the motor starts and stops. If that valve sticks open, the pump runs but can’t build tank pressure. See symptoms of a bad unloader valve. A technician can test both parts.
Look at the pump
If none of the checks above explain the problem, the pump itself may be worn. Worn piston rings, valves, or a head gasket can keep the pump from reaching full pressure. Signs include loud knocking, heavy oil use, unusual heat, or a pump that runs a long time without climbing. Pump repairs are technician work, and for some older or small units they may not be worth the cost.
Check the relief valve
The safety relief valve protects the tank from overpressure. If it vents at a pressure well below its rating, or it won’t close fully, the tank can’t build pressure. Don’t plug, adjust, or tamper with the relief valve. If it vents at the wrong pressure or won’t reseat, have it replaced.
When a load holds pressure down
If the tank reaches its cut-out pressure with no tools running, but the pressure sags while a tool runs, the compressor may simply be too small for that tool. A tool that uses a lot of air will pull pressure down faster than the pump can refill it. Test with no tools connected first, then with the tool running, and compare the two readings.
Safety
- Disconnect power and relieve pressure before you open any valve, switch, or pump.
- Never work on the tank itself. Tank repairs are for qualified shops.
- Don’t tamper with the relief valve. It is the last protection against overpressure.
For how the regulator and the tank pressure interact, see air compressor regulators. For draining the tank as part of a routine check, see how to start an air compressor.