Shop Air Systems

Air Manifolds: Running Several Tools From One Compressor

Run several air tools from one compressor with a manifold: choosing one, sizing demand against CFM, and adding shutoffs, regulators, and drains.

On this page
  1. What a manifold does
  2. Types of manifold
  3. Size for the tools you run together
  4. Plumb the manifold
  5. Shutoffs and regulators at each outlet
  6. Drains and moisture
  7. Common mistakes

An air manifold splits one air supply into several outlets, so several tools can connect at one station. A manifold doesn’t create more air. The compressor’s output limits how many tools can run at once, and the line feeding the manifold must be large enough to carry their combined demand. This article covers manifold types, sizing, and plumbing.

What a manifold does

A manifold takes one inlet and feeds two or more outlets. It can be a simple multi-port block, or it can have a shutoff valve or a regulator on each outlet. Its job is to make several connections convenient. It doesn’t add flow.

Types of manifold

  • Multi-port block. Simple, inexpensive, and compact. Every outlet is open whenever the supply is on, so you need a valve upstream to shut the station down.
  • Valve manifold. Each outlet has its own shutoff, so you can run one tool and close the rest.
  • Regulated manifold. Adds a regulator to an outlet, or to the whole manifold, for tools that need lower pressure than the line.
  • Quick-connect manifold. Outlets that take couplers for fast tool changes. Match the coupler style to your tools. See air coupler types.

Size for the tools you run together

The key number is airflow, usually measured in CFM (cubic feet per minute). Add up the CFM of the tools that will run at the same time, at the pressure they need. Compare that total with what your compressor delivers at that pressure, not with its tank rating alone. Leave some margin. A compressor’s delivered CFM drops as pressure rises, and tools rarely run at peak demand all the time.

Tools that run in short bursts are easier to supply than tools that run continuously. A tank or receiver adds reserve that helps with bursts of demand.

Plumb the manifold

  • Feed it from a properly sized line. The drop that feeds the manifold should be at least as large as the manifold’s inlet, and large enough for the combined demand.
  • Place a shutoff valve upstream of the manifold, so you can isolate the whole station.
  • Put a drain at the low point of the feed line, and at the manifold if its design allows.
  • Mount it where it’s accessible, at a height that keeps hoses off the floor.

Shutoffs and regulators at each outlet

Give each outlet its own shutoff. An idle outlet then doesn’t leak air, and a faulty hose can be isolated. If one tool needs a lower pressure than the others, put a regulator on that outlet rather than turning down the whole station. See air compressor regulators.

Drains and moisture

A manifold collects moisture like any other low point. Keep a drain at the low point of the feed line, and drain it regularly. A separator upstream of the manifold helps keep water out of the tools. For drop-leg and drain details, see shutoff valves and drop legs.

Common mistakes

  • Expecting more air. A manifold doesn’t add flow. Too many tools on one small line leads to weak tools and a compressor that never catches up.
  • Undersizing the feed. A small drop feeding a large manifold becomes the bottleneck.
  • Skipping the drain. Water pools at the manifold and reaches the tools.
  • Mixing coupler styles. Match them to avoid leaks.

For the full layout, see how to set up air compressor lines. For how line length and diameter affect delivered pressure, see how long an air hose can be before pressure drops.

The complete guide to shop air systems

How to Set Up Air Compressor Lines in Your Shop
Read the guide

Keep exploring

Guides from other topics

All topics →