Compressor Basics

How to break in an air compressor?

Learn how to break in a new air compressor, what the manual may require, and what to check during the first run, including the drain valve and oil level.

On this page
  1. Check the manual first
  2. What break-in is meant to do
  3. Typical break-in steps
  4. Warning signs during the first run
  5. Oil-free units and break-in oil
  6. After the break-in: routine care

Some compressors need a short break-in: a brief unloaded run with the tank drain and outlet open, followed by a check of the oil and for leaks. Many manuals describe this for oil-lubricated piston compressors. Oil-free units often have no break-in at all. Your owner’s manual sets the steps and the timing, so check it before you start.

Check the manual first

Not every compressor needs a break-in, and the times differ between models. Look in the owner’s manual for a break-in or first-use section. If it doesn’t mention one, follow the manual’s normal startup steps and the standard checks below.

What break-in is meant to do

Manufacturers describe break-in as a way to help the moving parts seat against each other and to let oil circulate before the unit runs under full pressure. A short unloaded run gives that time without the load of building tank pressure.

Typical break-in steps

The steps below are a general outline. The manual’s steps and times always come first.

  1. Read the manual. Confirm whether a break-in is required and how long it should run.
  2. Check the oil. On an oil-lubricated pump, fill to the marked level on the sight glass or dipstick, using the grade the manual specifies. Don’t overfill.
  3. Open the drain and outlet. Fully open the tank drain valve and any outlet lines, so air escapes freely and the unit builds little or no pressure.
  4. Run the unit unloaded. Start the compressor and let it run for the time the manual gives. Some manuals quote about 15 to 30 minutes. Keep the unit on a flat, ventilated surface.
  5. Close the drain and run a normal cycle. Turn the unit off, close the drain valve fully, and restart it. Let it build to its cut-out pressure, then check the fittings for leaks and confirm that it shuts off on its own.
  6. Recheck the oil. Some manuals call for an early oil change after the first hours of running. If yours does, follow that schedule.

Keep hands, sleeves, and tools clear of the belt and pulleys while the unit runs. Wear hearing protection, since compressors are loud.

Warning signs during the first run

Stop the unit and find the cause if you notice any of these:

  • Grinding, knocking, or a sharp metallic noise from the pump.
  • Oil leaking from the pump, the sight glass, or the seals.
  • A burning smell or smoke.
  • Heat that is much stronger than normal for the unit.
  • Pressure that doesn’t build, or a motor that won’t stop at cut-out.
  • Air leaking from fittings or the drain valve after it’s closed.

These can point to a problem that a break-in won’t fix. Check the manual’s troubleshooting section, and contact the manufacturer if the symptom continues.

Oil-free units and break-in oil

Oil-free compressors don’t have oil to break in, but the manual may still list a first-run check, such as tightening fittings or checking the drain. Follow it.

Some manuals specify a particular break-in oil. Others call for the regular compressor oil. Use the grade the manufacturer gives, and don’t substitute a different oil because it’s on sale.

After the break-in: routine care

Once the break-in is complete, the usual routine applies:

  • Drain the tank after use to remove the water that condenses inside it. Air receiver tanks explains the drain and the tank’s safety features.
  • Check the oil level on oil-lubricated units, and change the oil at the interval in the manual.
  • Keep the intake filter clean.
  • Listen for changes in sound or heat during normal use, since they can be early signs of wear.

For how oil-lubricated and oil-free designs differ in upkeep, see oil-free vs oil-lubricated air compressors. For the parts that make up the unit, see how an air compressor works.

The complete guide to compressor basics

How an Air Compressor Works: Parts and Principles Explained
Read the guide

Keep exploring

Guides from other topics

All topics →