An RV air compressor blowout adapter connects your compressor to the RV’s city water inlet, so you can blow water out of the supply lines before freezing weather. Many owners use this method instead of pink RV antifreeze. Pressure is the key safety point: too much air can split plastic or PEX lines and damage the water heater, pump or fittings. Read your RV owner’s manual first, and follow the manufacturer’s steps wherever they differ from this guide.
What the adapter is and how it connects
The adapter screws onto the city water inlet, which uses the same garden-hose thread as a standard hose. On the air side, most adapters use a 1/4-inch industrial quick-connect plug that snaps onto a compressor hose. Some styles use a Schrader valve instead. Some include a shut-off valve.
Adapters are made from solid brass, lead-free brass, or cheaper plastic and rubber. Basic plugs are inexpensive, and kits with a hose or a gauge cost more. Prices change, so check the current listing before you buy.
Set the pressure before you connect
Many RV owners and winterizing guides suggest keeping the air at roughly 30 to 40 PSI, and never much above 45 to 50 PSI, to avoid splitting plastic or PEX lines. Your RV manufacturer’s figure takes priority over any general number.
Use a regulator on the air supply so you can set the pressure and see it. Set it low before you turn the compressor on, not after.
Prepare the RV first
- Drain the fresh water tank, the water heater, the water filters, and every low-point drain. If you have a tankless water heater, drain it too.
- Follow your manual on the water heater. Some owners isolate or bypass it before blowing out, because pressure can damage it. Check the manual before deciding.
- Follow your manual on the water pump. Some guides run the pump briefly with the faucets open to clear bulk water. Do not run the pump dry.
Blow out the lines, one valve at a time
- Screw the adapter onto the city water inlet, and attach the compressor hose.
- Set the regulator low, in the range your manual gives, before you turn the compressor on.
- Open the low-point drains, then open each hot and cold faucet, the shower, and each toilet valve, one at a time.
- Blow air in, and wait until the water stops and only air comes out of each valve.
- Have someone inside the RV watch each valve, so you know when air is flowing and water has stopped.
- Go back to the water heater area and the fresh water tank, and blow air through again to check that no water remains.
- Empty the grey and black holding tanks.
- Turn the compressor off before you disconnect the hose.
Stop immediately if a joint leaks, a line will not clear, or a valve is still blowing water after a reasonable time. Do not raise the pressure to clear it faster. Check the line and the fitting first.
Mistakes to avoid
- Going above the regulator setting to clear a line faster.
- Leaving the compressor running unattended.
- Skipping the water heater, the low-point drains, or the grey and black tanks.
- Using a compressor with no regulator.
- Ignoring the RV manual’s steps for the pump and water heater.
What do you plug an air compressor into?
It depends on the compressor. A 12-volt unit plugs into the vehicle’s 12-volt socket or clamps to the battery. If you use one, start the engine first, so the battery does not drain.
A 120-volt compressor needs a standard household outlet, such as a campground site, or an inverter that can supply its power draw. Check the compressor’s voltage and power draw against your supply before you plug it in. Keep the cord and connections dry.
Plugging an RV into a house outlet uses a different connection, called shore power, and needs its own adapter. This guide covers only the blowout adapter.
Which compressor brand is most reliable?
There is no single answer. Reliability depends on the make, the use, and how the compressor is cared for. Look at the warranty, how easily parts are available, and reviews from owners who use a compressor in a similar way to you.
Antifreeze after blowing out
Many owners add RV-rated antifreeze to drains, traps and toilets after blowing out the lines. Use RV-rated antifreeze only. Automotive antifreeze is not safe for an RV’s water system.
Reconnecting in spring
When freezing weather is over, refill the fresh water tank, run the pump, and open each valve in turn to refill the lines. Check for leaks at each connection and flush the antifreeze out according to your manual.
For tire inflation on the same RV, see what size air compressor for RV tires. For portable compressor types, see vehicle air pumps. If the compressor itself will sit in the cold, see how to winterize an air compressor for storage.