Vehicle and Tire Air

How to pump air into your car tire?

Learn how to pump air into a car tire safely: find the right PSI on the door placard, check the pressure when cold, add air in short bursts, and recheck.

On this page
  1. Why the right pressure matters
  2. What you need
  3. Step 1: Find the recommended pressure
  4. Step 2: Check the pressure when the tires are cold
  5. Step 3: Add air in short bursts
  6. Step 4: Release extra air if you overfill
  7. Step 5: Replace the valve cap
  8. If the tire keeps losing air
  9. Common mistakes to avoid
  10. Gas station or home?

To pump air into a car tire, find the recommended pressure on the driver’s door placard or in the owner’s manual, check the tire’s pressure while it is cold, add air in short bursts, and check again. Do not aim for the maximum pressure printed on the tire’s sidewall. That number is the most the tire can safely hold, not the figure to set for your car.

Why the right pressure matters

Underinflated tires can wear unevenly, use more fuel and make steering feel less responsive. Overinflated tires have less of the tread on the road, which can reduce grip. Keeping to the recommended pressure helps with all three.

What you need

  • A tire pressure gauge you trust. Gas-station gauges can be inaccurate, so a personal gauge is worth carrying.
  • An air source: a gas-station air pump or a portable 12-volt inflator.
  • Your owner’s manual, or the door placard, to confirm the target pressure.

Open the driver’s door and look for the placard on the door jamb or the edge of the door. If it is missing, check the owner’s manual. Front and rear tires can have different recommended pressures, so check both. Some vehicles list a different pressure for a full load or for towing, and the manual is the best place to confirm it.

The number molded into the tire’s sidewall is the maximum for that tire. Treat it as a ceiling, not a target.

Step 2: Check the pressure when the tires are cold

Tire pressure rises as the air inside warms up, so a reading taken straight after a drive can be noticeably higher than a cold reading. Check your tires before you drive, or after the car has been parked for a few hours.

Remove the dust cap from each valve and keep it somewhere safe. Press your gauge firmly onto the valve stem. If you hear hissing, adjust the angle until the gauge seats and gives a steady reading.

Step 3: Add air in short bursts

Attach the pump’s nozzle or chuck straight onto the valve stem. Add air in short bursts of a few seconds, and check the reading between bursts. Stop when the tire reaches the target on the placard.

Many portable pumps are easier to handle if you switch them off before you attach or remove the chuck. If your pump has no automatic shut-off, stay with it and watch the gauge the whole time.

If you are using a gas-station pump, check the pressure with your own gauge once you have finished, because the built-in gauge may not match it.

Step 4: Release extra air if you overfill

If the tire goes over the target, press the small metal pin in the centre of the valve with a key, a pen tip or the edge of the dust cap. Release a little air, then check the reading again. Work in small steps, checking after each one.

Step 5: Replace the valve cap

Screw the dust cap back on. It keeps out dirt and moisture, which can contribute to slow leaks over time.

If the tire keeps losing air

A tire that needs air every few days may have a slow leak, a faulty valve or a puncture. Check the valve for bubbles with soapy water, look for a nail or screw in the tread, and recheck the pressure after a day or two.

If the tire is badly low or flat, do not drive far on it. A tire shop can usually find and repair a puncture. If a tire warning light is on, check all four tires against the placard and follow the owner’s manual for the warning system.

Common mistakes to avoid

  • Filling to the number on the sidewall. See can you overinflate a tire with an air compressor for why this matters.
  • Checking the tire straight after a long drive and then letting out too much air.
  • Trusting a gas-station gauge without checking it against your own.
  • Forgetting the spare. If you have time, check it too.
  • Running a small portable pump without breaks. A short duty cycle means it needs time to cool. See vehicle air pumps for what the duty-cycle rating means.

Gas station or home?

A gas-station air pump is convenient, but it may not be set up for your tire, and its gauge may be off. A portable inflator or a small home compressor lets you check and fill at home or on the road. For the time a fill takes, see how long it takes to fill a tire with an air compressor.

The complete guide to vehicle and tire air

Vehicle Air Pumps and Tire Inflators: A Buyer's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →