Vehicle and Tire Air

What size air compressor for RV tires?

What size air compressor for RV tires? Check the maximum pressure first, then airflow, duty cycle, power source and hose length for your rig.

On this page
  1. Find the pressure your RV tires need
  2. Maximum pressure: check it first
  3. Airflow and duty cycle
  4. 12-volt, 120-volt or tank?
  5. Hose length and chuck
  6. Safety when inflating RV and truck tires
  7. Common mistakes
  8. Quick size guide by RV type

For most RVs, the right compressor is one whose maximum pressure comfortably exceeds the pressure your tires need, with enough airflow and a duty cycle that can finish a tire in a reasonable time. A small 12-volt car inflator is often rated below the pressure that RV tires need, and many RV and truck-based tires are rated at 80 PSI or higher. Work out the pressure your tires need from the weight on each axle before you choose a unit.

Find the pressure your RV tires need

Start with the tires, not the compressor. The sidewall gives the maximum pressure for that tire, but the pressure you should run depends on how much weight each axle carries. Tire makers publish load-and-inflation tables that match a tire’s load to a pressure.

To use one, you need the weight on each axle. You can get it by weighing the RV at a truck stop with a public scale, which usually gives front, rear and trailer axle weights. Then use the table for your tire size to find the pressure.

Many gas-station air pumps are set up for car tires, which usually need far less pressure, so do not rely on one for an RV top-up.

Maximum pressure: check it first

The compressor’s maximum pressure must be above the pressure your tires need, with some margin. One RV owner whose motorhome has tires rated to about 110 PSI cold said the compressor’s maximum had to match that figure. Small 12-volt units are often rated well below RV pressures, so check the spec sheet before you buy.

A reviewer who tested portable inflators suggested that a maximum of about 120 PSI is plenty for most drivers, and that bigger rigs may need up to about 150 PSI.

Airflow and duty cycle

Airflow, measured in CFM, decides how quickly a pump fills a tire, and it falls as the pressure rises. Filling an RV tire near its top pressure can therefore take noticeably longer than the early part of the fill.

Duty cycle decides how long the pump can run before it must rest. A pump with a 33% duty cycle can run for about 20 minutes in an hour, then needs about 40 minutes to cool. For a large tire at high pressure, a pump with a short duty cycle may need to rest more than once, so plan the work around it.

12-volt, 120-volt or tank?

  • 12-volt portable units run from the vehicle battery or a 12-volt socket. They are small and easy to carry, which suits a motorhome, a tow vehicle or an off-road rig. They are generally slower on large tires, and they draw from the battery, so start the engine first.
  • 120-volt units are larger and heavier. They need a dependable supply, such as a campground outlet, or an inverter and battery bank large enough for the compressor. Check the compressor’s power draw against the inverter’s rating before you rely on it.
  • Tank compressors can fill tires quickly and run air tools, but they need a 120-volt supply and take up more room.

Hose length and chuck

Dual rear wheels can sit well away from the compressor. Check the hose length and the power-cord length against where your tires are. Quick-connect hose ends make it easy to replace or extend the hose. A chuck with a 90-degree head or a clip-on design lets you stand to the side of the tire while filling it.

Safety when inflating RV and truck tires

Large tires can fail during inflation, so keep your distance:

  • Stand to the side of the tire, not in front of it or over it.
  • Use a long hose and a chuck that lets you work from a distance.
  • Inflate to the pressure from your load table, not the number on the sidewall.
  • Check the gauge often, and let the pump cool if it stops.
  • If a tire has come off its bead, or a bead will not seat, stop and have a tire shop deal with it.

For more on pressure and overfilling, see can you overinflate a tire with an air compressor.

Common mistakes

  • Choosing a compressor on price alone and finding its maximum pressure is too low for the tires.
  • Setting pressure by feel instead of from the load table.
  • Checking pressure on warm tires, which reads high.
  • Forgetting that some RVs do not come with tire pressure monitors. Owners often add one, which can give an early warning of a leak or a fall in pressure.

Quick size guide by RV type

Rather than a single size, match the compressor to the rig:

  • Small camper van or Class B: tires may be rated around 80 PSI, so a higher-rated 12-volt unit with a long hose may be enough.
  • Class A or Class C motorhome: tires may be rated above 100 PSI. Look for a unit that reaches that pressure with margin and has a long hose.
  • Towable trailer with dual wheels: check the hose reach and duty cycle, because filling several tires takes time.

For the basics of 12-volt and portable units, see vehicle air pumps. For how long a fill takes, see how long it takes to fill a tire with an air compressor.

The complete guide to vehicle and tire air

Vehicle Air Pumps and Tire Inflators: A Buyer's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →